Custom Query (98 matches)

Hi I created a slice (transgeo) with two raw nodes and two vms. The topology should look like: pc1-pc2-vm1-vm2

Notice that pc1 and pc2 are my clientIds and not the actual pc names (I know very unfortunate naming)

pc1 was mapped to pc3.instageni.gpolab.bbn.com and pc2 was mapped to pc4.instageni.gpolab.bbn.com

I asked for a custom Ubuntu image to be loaded in both machines. pc4.instageni.gpolab.bbn.com has indeed an Ubuntu image loaded while pc43.instageni.gpolab.bbn.com has a fedora one.

The rspec is attached

I have created a slice (transgeo) see ticket #100 and I can't login to my VMs. Looking closer for both VMs pc1.instageni.gpolab.bbn.com was assigned and the port for logging in is 11000 for both.

The error I get is :

ssh: connect to host pc1.instageni.gpolab.bbn.com port 11000: Connection refused

The rspec is attached to ticket #100

Using version ??? on 04/25/2012, sent email to ​instageni-ops@flux.utah.edu:

Created a sliver with 2 OpenVZ hosts, the sliver was created successfully, but the sliverstatus shows that the 'pg_status' is 'not ready'. Attempts to login to the 2 nodes fail with a timeout. Connections were attempted over 40 minutes after sliver creation. This problem is reproducible

Response to the email:

On 4/25/12 11:15 PM, Robert Ricci wrote:

At this point, we are still debugging some problems in our OpenVZ image - our older Fedora 10 based image has trouble booting on the machines in these racks, and so we've had to move to a newer Fedora 15 image. We've resolved several obstacles with that image, but there are still a few kinks to iron out. We will keep you updated.