wiki:GENIRacksHome/InstageniRacks/AcceptanceTestStatus/IG-EXP-4

Version 3 (modified by lnevers@bbn.com, 7 years ago) (diff)

--

IG-EXP-4: InstaGENI Multi-site Acceptance Test

This page captures status for the test case IG-EXP-4, which verifies the ability to support basic operations of VMs and data flows between two racks. For overall status see the InstaGENI Acceptance Test Status page.

Test Status

This section captures the status for each step in the acceptance test plan.

Step State Date completed Ticket Comments
Step 1 Color(orange,Blocked)? BBN Rack is not available yet
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9
Step 10
Step 11
Step 12
Step 13
Step 14
Step 15
Step 16
Step 17
Step 18
Step 19


State Legend Description
Color(green,Pass)? Test completed and met all criteria
Color(#98FB98,Pass: most criteria)? Test completed and met most criteria. Exceptions documented
Color(red,Fail)? Test completed and failed to meet criteria.
Color(yellow,Complete)? Test completed but will require re-execution due to expected changes
Color(orange,Blocked)? Blocked by ticketed issue(s).
Color(#63B8FF,In Progress)? Currently under test.


Test Plan Steps

  1. As Experimenter1, Request ListResources from BBN InstaGENI.
  2. Request ListResources from Utah InstaGENI.
  3. Review ListResources output from both AMs.
  4. Define a request RSpec for a VM at BBN InstaGENI.
  5. Define a request RSpec for a VM at Utah InstaGENI and an unbound exclusive non-OpenFlow VLAN to connect the 2 endpoints.
  6. Create the first slice.
  7. Create a sliver at each InstaGENI aggregate using the RSpecs defined above.
  8. Log in to each of the systems, and send traffic to the other system, leave traffic running.
  9. As Experimenter2, Request ListResources from BBN and Utah InstaGENI.
  10. Define a request RSpec for one VM and one bare metal node in the BBN InstaGENI rack. Each resource should have two logical interfaces and a 3rd VLAN for the local connection.
  11. Define a request RSpec to add two VMs at Utah and two VLANs to connect the BBN InstaGENI to the Utah InstaGENI.
  12. Create a second slice.
  13. In the second slice, create a sliver at each InstaGENI aggregate using the RSpecs defined above.
  14. Log in to each of the end-point systems, and send traffic to the other end-point system which shares the same VLAN.
  15. Verify traffic handling per experiment, VM isolation, and MAC address assignment.
  16. Construct and send a non-IP ethernet packet over the data plane interface.
  17. Review baseline monitoring statistics.
  18. Run test for at least 4 hours.
  19. Review baseline monitoring statistics.
  20. Stop traffic and delete slivers.

Attachments (2)

Download all attachments as: .zip