Changes between Version 2 and Version 3 of WiMAXInteg/CampusInstallation/ODUPowerCable


Ignore:
Timestamp:
06/25/10 20:41:25 (14 years ago)
Author:
Ivan Seskar
Comment:

--

Legend:

Unmodified
Added
Removed
Modified
  • WiMAXInteg/CampusInstallation/ODUPowerCable

    v2 v3  
    1111Disassemble the connector by unscrewing the small screw shown in Figure 1 with appropriate Allen wrench.
    1212
    13 [[Image()]]
     13[[Image(ODU-Allen-Screw.jpg, width=300)]]
    1414
    15 The cable wires have to be soldered to the connector as shown in figures 2.
     15The top of the connector has to be un-screwed from the protective body in order to expose the soldering contacts and the cable wires have to be soldered as shown in figures 2.
    1616
    17 [[Image(ODU-Power-Connector.jpg, width=200 )]]
     17[[Image(ODU-Power-Connector.jpg, width=300 )]]
    1818
    1919ODU Power Connector assembly is shown in figure 3. Once assembled and attached to the ODU, the connector has to be weatherproofed (as suggested on Page 51 of the [http://groups.geni.net/geni/attachment/wiki/WiMAXInteg/CampusInstallation/BS_INSTALLATION.pdf NEC Installation Manual for Base Station (IMN:BS)]).
     
    2121[[Image(ODU-Power-Cable.jpg, width=400)]]
    2222
    23 The other end of the cable is attached to the Mean Well power supply as shown in Figure 4 (note that grounding should wire should not be used if the power supply and 110V is not available on the roof)
     23The other end of the cable is attached to the Mean Well power supply as shown in Figure 4 (note that grounding should wire should not be used if the ODU power supply is in the equipment room as shown in Figure 3-9 on Page 49 of [http://groups.geni.net/geni/attachment/wiki/WiMAXInteg/CampusInstallation/BS_INSTALLATION.pdf NEC Installation Manual for Base Station (IMN:BS)])
    2424
    25 [[Image(ODU-MW-PS.jpg, width=200)]]
     25[[Image(ODU-MW-PS.jpg, width=300)]]