Changes between Version 1 and Version 2 of WiMAXInteg/CampusInstallation/ODUPowerCable


Ignore:
Timestamp:
06/25/10 20:31:32 (14 years ago)
Author:
Ivan Seskar
Comment:

--

Legend:

Unmodified
Added
Removed
Modified
  • WiMAXInteg/CampusInstallation/ODUPowerCable

    v1 v2  
    99    * One power supply for ODU, Mean Well SP-200-48, 110VAC input, -48VDC output, rated 4.2A or 200W
    1010
     11Disassemble the connector by unscrewing the small screw shown in Figure 1 with appropriate Allen wrench.
    1112
    12 The cable has to be soldered to the connector as shown in figures 1 and 2
     13[[Image()]]
    1314
    14 ||[[Image(ODU-Power-Connector.jpg, 200px )]]||[[Image(ODU-Power-Cable.jpg, 200px)]]||
     15The cable wires have to be soldered to the connector as shown in figures 2.
    1516
    16 The other end of the cable is attached to the Mean Well power supply (note that grounding should wire should not be used if the power supply and 110V is not available on the roof)
    17 [[Image(ODU-MW-PS.jpg)]]
     17[[Image(ODU-Power-Connector.jpg, width=200 )]]
     18
     19ODU Power Connector assembly is shown in figure 3. Once assembled and attached to the ODU, the connector has to be weatherproofed (as suggested on Page 51 of the [http://groups.geni.net/geni/attachment/wiki/WiMAXInteg/CampusInstallation/BS_INSTALLATION.pdf NEC Installation Manual for Base Station (IMN:BS)]).
     20
     21[[Image(ODU-Power-Cable.jpg, width=400)]]
     22
     23The other end of the cable is attached to the Mean Well power supply as shown in Figure 4 (note that grounding should wire should not be used if the power supply and 110V is not available on the roof)
     24
     25[[Image(ODU-MW-PS.jpg, width=200)]]