wiki:WIMXUCO

Version 13 (modified by caleb.phillips@colorado.edu, 8 years ago) (diff)

update the installation checklist, contact into, and current status

Project Number

1768

Project Title

Deploying GENI WiMax in Colorado
a.k.a WIMXUCO

Technical Contacts

PI: Dirk Grunwald Dirk.Grunwald@Colorado.edu
Ph.D. Student: Caleb Phillips caleb.phillips@Colorado.EDU

Participating Organizations

University of Colorado at Boulder CS Dept.
Computer Science Systems Laboratory

Related Projects

Open GENI WiMAX Base Station Kit for Campus Deployments

GPO Liaison System Engineer

Harry Mussman hmussman@geni.net

Scope

This proposal will install and maintain a programmable WiMax base station at one of the existing University of Colorado Wide-Area Radio Testbed (WART) wireless network sites. It will use a “GENI WiMax Base Station Kit” provided by Rutgers.

Current Capabilities

  • Base Station is installed at 40.007422,-105.263173 with 120-degree sector pointed towards true-North.
  • As of 6/17/2011, PHY-layer is operational and transmitting, putting 40 dBm into the antenna cable. Demodulation achieved with an Anritsu Spectrum analyzer both at the base of the antenna (CINR =~ 45 dB) and 100m distant in the main lobe (CINR =~ 43 dB).

Milestones

MilestoneDate(WIMXCOLUM: S2.a Redesign remote management/power system)?
MilestoneDate(WIMXCOLUM: S2.b Install the WiMax base station kit and antennas)?
MilestoneDate(WIMXUCO: S3.a Demonstration at GEC9 and Experimenter Outreach)?
MilestoneDate(WIMXUCO: S3.b Documentation and Code Release)?
MilestoneDate(WIMXUCO: S3.c Demonstration at GEC10 and Experimenter Outreach)?
MilestoneDate(WIMXUCO: S3.d Documentation and Code Release)?
MilestoneDate(WIMXUCO: S3.e Demonstration at GEC11 and Experimenter Outreach)?
MilestoneDate(WIMXUCO: S3.f Documentation and code release)?

Campus Installation Checklist

University of Colorado at Boulder

Contact(s):
PI: Dirk Grunwald Dirk.Grunwald@Colorado.edu

Step Description Planned Started Completed Comment
1 Identify Outdoor Site on Campus - - X Chosen site is on the roof of the Engineering Center Office Tower (ECOT)
2 Obtain FCC License - - X Operating (legally) at 2.5 GHz
3 Identify Indoor Equipment Room on Campus - - X IDU and ASN-Gateway are located in a wall-mounted NEMA-4 enclosure on the roof.
4 Install Wiring at Outdoor Site and to Indoor Equipment Room - - X Completed by contractor.
5 Install Pole at Outdoor Site and Ground - - X Completed by contractor.
6 Install Antenna at Outdoor Site - - X Completed by contractor. Aimed at true north with 2-degrees mechanical down-tilt.
7 Install Base Station Outdoor Unit - - X Completed by Contractor
8 Complete Wiring at Outdoor Site and to Indoor Equipment Room - - X Completed by Contractor
9 Install Indoor Equipment Racks and Ground - - X Completed by Contractor
10 Install 120VAC and -48VDC Power Feeds and/or Supplies - - X Completed by Contractor
11 Install Base Station Indoor Unit - - X Completed by Contractor
12 Complete Wiring of Base Station Indoor Unit - - X Completed by Contractor
13 Initial Check-Out of Antenna and Base Station Outdoor and Indoor Units - - X Not sure what this means, but yes?
14 Install Ethernet (VLAN) Switch, or Identify Existing Capacity - - X Completed after negotiations with ITS.
15 Install Linux Server(s) and Software - - X Completed with help from Ivan.
16 Connect Backbone Network - - X ASN-Gateway is accessible at 128.138.224.29
17 Provide Reference Client Platform X - - Working with Intel chipset with some agony.
18 Initial Check-Out of Campus WiMAX Testbed X - - PHY-Level measurements demonstrate functionality. Need to try client-connectivity and throughput testing. Still need to get GRE tunnel/routing working.

Quarterly Status Reports

Spiral 2 Review

Technical Documents

No technical documents at the moment.

Software Releases

No software at the moment.

Connectivity

Attachments (1)

Download all attachments as: .zip