| 47 | |
| 48 | '''Rough steps for install''' |
| 49 | * Install hardware |
| 50 | * Rack the switch |
| 51 | * Power up the switch |
| 52 | * Ensure !OpenFlow firmware is installed |
| 53 | * Configure switch |
| 54 | * Set up the control plane connectivity |
| 55 | * Ensure that a control plane exists between the !OpenFlow switch and the FlowVisor machine |
| 56 | * Ensure that the FOAM installation is publicly accessible |
| 57 | * Set up FOAM and FlowVisor |
| 58 | * !FlowVisor: |
| 59 | * Recommended version: 0.8.1.2 |
| 60 | * Instructions: http://groups.geni.net/geni/wiki/FlowVisor |
| 61 | * FOAM: |
| 62 | * Recommended version: 0.6.3 or 0.6.4 |
| 63 | * Installation instructions: http://groups.geni.net/geni/wiki/OpenFlow/FOAM |
| 64 | * Coordinate with the GPO for testing |
| 65 | * Connect to data plane to upstream connection |
| 66 | * Before actually establishing a connection, open a GMOC ticket |
| 67 | * Coordinate with the GMOC on the date for establishing connectivity |
| 68 | * Coordinate with the GPO for testing (again) |
| 69 | * Set up monitoring |
| 70 | * Coordinate with the GMOC for setting your site up to submit active monitoring |
| 71 | * Set up active FOAM monitoring |
| 72 | * Coordinate with Tim at the GPO to set up passive monitoring |