Changes between Version 35 and Version 36 of OpenFlow/FOAM


Ignore:
Timestamp:
12/11/12 11:07:30 (11 years ago)
Author:
Josh Smift
Comment:

--

Legend:

Unmodified
Added
Removed
Modified
  • OpenFlow/FOAM

    v35 v36  
    3535== Initial configuration ==
    3636
    37 When you install FOAM for the first time (i.e. not an upgrade to an existing installation), you should configure e-mail; those steps are part of the official [https://openflow.stanford.edu/display/FOAM/0.8.x+Install+Guide FOAM 0.8 install guide].
     37When you install FOAM for the first time (i.e. not an upgrade to an existing installation), you should configure its ability to send you administrative e-mail; those steps are part of the official [https://openflow.stanford.edu/display/FOAM/0.8.x+Install+Guide FOAM 0.8 install guide].
    3838
    3939We typically put the FOAM admin password into /opt/foam/etc/foampasswd, so you don't have to type it every time you run a foamctl command. Make sure that it's only readable by people who should have full admin access to FOAM on your system! (World-readable might be fine if only FOAM admins have accounts on your FOAM server; or you might want to make it only group-readable by a group that includes the FOAM admins.) The examples on the rest of this page assume that you've done that.
     
    5151foamctl config:set-value --key="geni.site-tag" --value="foam.gpolab.bbn.com" --passwd-file=/opt/foam/etc/foampasswd
    5252}}}
     53
     54You should then install and configure the FOAM monitoring package; we have a separate [wiki:PlasticSlices/MonitoringRecommendations/FoamConfiguration guide] for that.
    5355
    5456Finally, for GENI purposes, we recommend also configuring your admin e-mail (which causes it to show up in sliverstatus), and max lease: