Changes between Version 10 and Version 11 of GeniTmixCalibTutorial
- Timestamp:
- 06/19/14 14:32:26 (10 years ago)
Legend:
- Unmodified
- Added
- Removed
- Modified
-
GeniTmixCalibTutorial
v10 v11 36 36 You should see a tmix.conf file, which contains the configuration for a tmix experiment. Open the file with an editor such as vim, emacs, or nano, and browse its contents. These are various settings that control a tmix experiment. At the end of the file notice the Crecv_Trace and Cinit_Trace lines. These are the only lines you will need to change as we run our calibration experiments. 37 37 38 3. List the contents of the tmix data directory by typing the following on either node:38 4. List the contents of the tmix data directory by typing the following on either node: 39 39 {{{ 40 40 ls /opt/tmix-1.2/data … … 54 54 Crecv_Trace = /opt/tmix-1.2/data/1of10.cinit.tcvec 55 55 }}} 56 Tmix relies upon a pre-determined start time to synchronize tmix on the two nodes. On both nodes run the following command to determine the time and date: 56 on the "right" node. 57 Note that the filenames are swapped on the "right" node. All you should need to change is what is after "data/" and before ".cinit" or ".crecv". You are now ready to run the tmix experiment. 58 59 2. Tmix relies upon a pre-determined start time to synchronize tmix on the two nodes. On both nodes run the following command to determine the time 2.and date: 57 60 {{{ 58 61 date