This page is located at ​http://groups.geni.net/geni/wiki/GeniDesktop/Summer_Camp_2015

GENI Desktop Tutorial (Summer Camp 2015 UConn)

This tutorial consists of three parts:

• Basic GENI Desktop Operations
• Brief Introduction to OpenFlow
• Flow Installation and Monitoring in GENI Desktop

I. Basic GENI Desktop Operations

A general tutorial for GENI Desktop can be found at ​http://groups.geni.net/geni/wiki/GENIExperimenter/Tutorials/GENIDesktop

• Part I: Design/Setup

Follow the instructions of Part I: Design/Setup of the tutorial to create a three-node topology.

• Part II: Excute
  • Step A: Copy a file to the selected nodes.
  • Step B: Login to the selected nodes.
  • Step C: Run a command on the selected nodes.
  • Step D: Copy a file from the selected nodes.
  • Step E: Monitor the traffic of the selected interface.

• Part III: Finish
  • Teardown experiment

II. Introduction to OpenFlow

A brief introduction to OpenFlow can be found at [ ]

III. Flow Installation and Monitoring

• Part I: Design/Setup
  • Step A: Create two slices, one for the controller and one for an experiment using OVS nodes.
    • Pick "Public IP address" for the controller node.
    • The slice with OVS nodes consists of three OVS nodes and two Xen nodes.
  • Step B: Figure out the IP
  • Step C: Run an initialization script to point

• Part II: Execute
  • Install, list, and delete flows on the experiment
  • Monitor per-flow performance

• Part III: Finish
  • Teardown experiment