wiki:GeniDesktop/Manual/gdfeatures/run

Version 6 (modified by Hussamuddin Nasir, 8 years ago) (diff)

--

Navigation: Index/Next

Run Command Module

If you would like to run a linux command/script on one or more nodes in your slice , you should use this module. To do so

  1. Click on the Command button. In the small window that shows up as shown in the figure below,

2a. Select the node/nodes on which you want run your command.

2b. click on the Set Selection button. Make sure you see your selected nodes listed below that button.

  1. Then type in the command you would like to run. You can join multiple commands separated by a ;. (Commands are executed in a bash shell)

Once the commands are run, you will see the results of the commands pop up in a new browser tab/window. (See figure below)

Navigation: Index/Next

Attachments (3)

Download all attachments as: .zip