Version 11 (modified by 8 years ago) (diff) | ,
---|
Run Command Module
If you would like to run a linux command/script on one or more nodes in your slice , you should use this module. To do so
- Click on the Command button. In the small window that shows up as shown in the figure below.
2.
(a) Select the node/nodes on which you want run your command.
(b) Click on the Set Selection button. Make sure you see your selected nodes listed below that button.
- Then type in the command you would like to run. You can join multiple commands separated by a ;. (Commands are executed in a bash shell)
Once the commands are run, you will see the results of the commands pop up in a new browser tab/window. (See figure below)
Attachments (3)
- 3.png (9.7 KB) - added by 8 years ago.
- 4.png (34.4 KB) - added by 8 years ago.
- 5.png (6.3 KB) - added by 8 years ago.
Download all attachments as: .zip