Navigation: [wiki:GeniDesktop/Manual/gdfeatures Index]/[wiki:GeniDesktop/Manual/gdfeatures/file_upload_direct Next]
[[PageOutline(1-10)]]

= Run Command Module =
 
If you would like to run a linux command/script on one or more nodes in your slice , you should use this module. To do so


[[Image(3.png)]][[Image(4.png)]]

 
1. Click on the '''Command''' button. In the small window that shows up as shown in the figure below.[[br]]2.[[br]](a) Select the node/nodes on which you want run your command.[[br]](b) Click on the '''Set Selection''' button. Make sure you see your selected nodes listed below that button.[[br]]3. Then type in the command you would like to run. You can join multiple commands separated by a ''';'''. (Commands are executed in a bash shell)[[br]]

Once the commands are run, you will see the results of the commands  pop up in a new browser tab/window. (See figure below)


[[Image(5.png)]]

Navigation: [wiki:GeniDesktop/Manual/gdfeatures Index]/[wiki:GeniDesktop/Manual/gdfeatures/file_upload_direct Next]