Changes between Version 6 and Version 7 of GeniDesktop/Manual/gdfeatures/run


Ignore:
Timestamp:
05/12/16 16:44:55 (8 years ago)
Author:
Hussamuddin Nasir
Comment:

--

Legend:

Unmodified
Added
Removed
Modified

  • GeniDesktop/Manual/gdfeatures/run

    v6 v7  
    1010
    1111 
    12 1. Click on the '''Command''' button. In the small window that shows up as shown in the figure below,
     12 1. Click on the '''Command''' button. In the small window that shows up as shown in the figure below,
    1313
    14 2a. Select the node/nodes on which you want run your command.
     14 2a. Select the node/nodes on which you want run your command.
    1515
    16 2b. click on the '''Set Selection''' button. Make sure you see your selected nodes listed below that button.
     16 2b. click on the '''Set Selection''' button. Make sure you see your selected nodes listed below that button.
    1717
    18 3. Then type in the command you would like to run. You can join multiple commands separated by a ''';'''. (Commands are executed in a bash shell)
     18 3. Then type in the command you would like to run. You can join multiple commands separated by a ''';'''. (Commands are executed in a bash shell)
    1919
    2020Once the commands are run, you will see the results of the commands  pop up in a new browser tab/window. (See figure below)