Changes between Version 44 and Version 45 of GENIRacksHome/ExogeniRacks/AcceptanceTestStatus/EG-EXP-6

Timestamp:

09/12/12 16:32:12 (12 years ago)

Author:

lnevers@bbn.com

Comment:

--

GENIRacksHome/ExogeniRacks/AcceptanceTestStatus/EG-EXP-6

@@ -2 +2 @@
 = EG-EXP-6: ExoGENI and Meso-scale Multi-site !OpenFlow Acceptance Test =
 
-This page captures status for the test case EG-EXP-6, which verifies ExoGENI rack interoperability with other meso-scale GENI sites. For overall status see the [wiki:GENIRacksHome/ExogeniRacks/AcceptanceTestStatus ExoGENI Acceptance Test Status] page. ''Last update: 08/14/12''
+This page captures status for the test case EG-EXP-6, which verifies ExoGENI rack interoperability with other meso-scale GENI sites. For overall status see the [wiki:GENIRacksHome/ExogeniRacks/AcceptanceTestStatus ExoGENI Acceptance Test Status] page. ''Last update: 09/12/12''
 
 
@@ -736 +736 @@
 Verify that no default controller, switch fail-open behavior,  or other resource other than experimenters' controllers, can control how traffic flows on network resources assigned to  experimenters' slivers.
 
-Verified that traffic is not exchanged when the controller is not running. Verified that starting controller allows traffic to be delivered.
+The following scenarios were verified:
+ * Traffic is not exchanged when the controller is not running. 
+ * Starting controller allows existing traffic flows to be delivered.  
+ * Stopping the controller does not stop an existing continuous traffic exchange. 
+ * Stopping the controller and starting a flow within the "DEFAULT_FLOW_TIMEOUT" (5 sec) allow traffic delivery.
+ * Stopping the controller and starting a flow after the "DEFAULT_FLOW_TIMEOUT" (5 sec) does not allow traffic delivery.
 
 
 == 31. Set the hard and soft timeout of flowtable entries ==
 
+The following scenarios were verified with a modified soft timeout by modifying the "DEFAULT_FLOW_TIMEOUT" in the file src/include/openflow-default.hh:
+ * Stopping the controller and starting a flow within the "DEFAULT_FLOW_TIMEOUT" (25 sec) allow traffic delivery.
+ * Stopping the controller and starting a flow after the "DEFAULT_FLOW_TIMEOUT" (25 sec) does not allow traffic delivery.
+
+Flow removed (src/include/flow-removed.hh) 
+
 == 32. Get switch statistics and flowtable entries for slivers from the OpenFlow switch. ==
 
@@ -747 +758 @@
 Information was captured in earlier steps where the console command was used to show which switches were connected to the NOX controller in step 28 above.
 
-Following is an example where experiment 3 is partially set up, and the topology is checked to verify that is reflect the slivers created:
+Following is an example where experiment 3 is partially set up with sliver at the BBN ExoGENI and the BBN Meso-scale site only. The topology is checked to verify that it only shows the switches for the slivers created:
 {{{
 $  ./nox-console -n localhost -p 11020 getnodes | sort
-00:00:00:10:10:17:50:01   ## OF switch at Rutgers
 00:01:08:17:f4:b5:2a:00   ## ExoGENI BBN Switch 
 06:d6:00:12:e2:b8:a5:d0   ## OF switch at BBN (jalapeno) to NLR