Changes between Version 16 and Version 17 of GENIRacksHome/ExogeniRacks/AcceptanceTestStatus/EG-EXP-6

Timestamp:

08/07/12 10:25:13 (12 years ago)

Author:

lnevers@bbn.com

Comment:

--

GENIRacksHome/ExogeniRacks/AcceptanceTestStatus/EG-EXP-6

@@ -260 +260 @@
 }}}
 
-== 25. Log in to each of the compute resources in the slice, and configure data plane network interfaces on any non-ExoGENI resources as necessary, and send traffic to each other systems; leave traffic running.
+== 25. Log in to each of the compute resources in the slice ==
 
 Determine compute resources allocated to the sliver in the BBN ExoGENI rack. First make sure the sliverstatus is ready and once the sliver is ready get the host allocated with Omni:
@@ -283 +283 @@
     <login authentication="ssh-keys" hostname="pc9.pgeni.gpolab.bbn.com" port="22" username="lnevers"/>  
 
-
-== 26. Verify that all three experiments continue to run without impacting each other's traffic and verify that data is exchanged over the path along which data is supposed to flow ==
+Login to each node in the slice, onfigure data plane network interfaces on any non-ExoGENI resources as necessary, and send traffic to each of the other systems; leave traffic running.
+
+
+== 26. Verify that all three experiments continue to run ==
+Verify that each experiment is running without impacting each other's traffic and verify that data is exchanged over the path along which data is supposed to flow 
  
 == 27. Review baseline, GMOC, and monitoring statistics ==
@@ -292 +295 @@
 == 29. As Experimenter3, verify that traffic only flows on the network resources assigned to slivers as specified by the controller ==
 
-== 30. Verify that no default controller, switch fail-open behavior, or other resource other than experimenters' controllers, can control how traffic flows on network resources assigned to experimenters' slivers ==
- 
-== 31. Set the hard and soft timeout of flowtable entries ==
-
-== 32. Get switch statistics and flowtable entries for slivers from the !OpenFlow switch. ==
-
-== 33. Get layer 2 topology information about slivers in each slice ==
-
-== 34. Install flows that match on layer 2 fields and/or layer 3 fields ==
 
 == 35. Run test for at least 4 hours ==