= EG-EXP-4: ExoGENI Multi-site Acceptance Test = This page captures status for the test case EG-EXP-4, which verifies the ability to support basic operations of VMs and data flows between two racks. For overall status see the [wiki:GENIRacksHome/ExogeniRacks/AcceptanceTestStatus ExoGENI Acceptance Test Status] page. = Test Status = This section captures the status for each step in the acceptance test plan. || '''Step''' || '''Status''' || '''Date completed''' ||''' Ticket ''' || '''Comments''' || || Step 1 || || || || || || Step 2 || || || || || || Step 3 || || || || || || Step 4 || || || || || || Step 5 || || || || || || Step 6 || || || || || || Step 7 || || || || || || Step 8 || || || || || || Step 9 || || || || || || Step 10 || || || || || || Step 11 || || || || || || Step 12 || || || || || || Step 13 || || || || || || Step 14 || || || || || || Step 15 || || || || || || Step 16 || || || || || || Step 17 || || || || || || ''Status Legend'' || ''Description '' || || || || [[Color(green,Pass)]] || Test completed and met all criteria || || [[Color( #5adefa, #100000 , Pass)]] || Test completed and met most criteria. Exceptions documented|| || [[Color(red,Fail)]] || Test completed and failed to meet criteria. || || [[Color(orange,Blocked)]] || Blocked by ticketed issue(s). || || In progress || Currently under test. || = Test Plan Steps = 1. As Experimenter1, Request !ListResources RENCI ExoGENI. 2. Review !ListResources output. 3. Define a request RSpec for a VM at BBN ExoGENI, a VM at RENCI ExoGENI and an unbound exclusive non-!OpenFlow VLAN to connect the 2 endpoints. 4. Create the first slice. 5. Create a sliver at the RENCI ExoGENI aggregate using the RSpecs defined above. 6. Log in to each of the systems, and send traffic to the other system, leave traffic running. 7. As Experimenter2, Request !ListResources from RENCI ExoGENI. 8. Define a request RSpec for one VM and one bare metal node each with two interfaces in the BBN ExoGENI rack, two VMs at RENCI, and two VLANs to connect the BBN ExoGENI to the RENCI ExoGENI. 9. Create a second slice. 10. In the second slice, create a sliver at the RENCI ExoGENI aggregate using the RSpecs defined above. 11. Log in to each of the end-point systems, and send traffic to the other end-point system which shares the same VLAN. 12. Verify traffic handling per experiment, VM isolation, and MAC address assignment. 13. Construct and send a non-IP ethernet packet over the data plane interface. 14. Review baseline monitoring statistics. 15. Run test for at least 4 hours. 16. Review baseline monitoring statistics. 17. Stop traffic and delete slivers.