Changes between Version 14 and Version 15 of GENIRacksAdministration/OpenGENIFAQ

Timestamp:

05/29/14 13:40:42 (10 years ago)

Author:

lnevers@bbn.com

Comment:

--

GENIRacksAdministration/OpenGENIFAQ

@@ -70 +70 @@
 === Q. How can I tell and change the current switch configuration? ===
 
-SSH access to the switch should be enabled, allowing you to receive the FTOS (Force-ten OS) prompt.
-
-From there you can check current switch configuration from commands such as:
+The OpenGENI rack has two switches:
+  * 1 Dell !PowerConnect 7048 Switch for access to the external internet [http://www.dell.com/support/Manuals/us/en/19/product/powerconnect-7048r Manuals] 
+  * 1 Dell Force10 S4810P !OpenFlow switch. [http://www.dell.com/support/Manuals/us/en/04/Product/force10-s4810 Manuals]
+
+SSH access is enabled to both switches on the Control Plane Network, where the two switches usually have been assigned these addresses:
+  - Force10 OpenFlow Switch - 10.10.8.200
+  - PowerConnect 7048 Switch - 10.10.8.201
+ 
+Once you are logged into the !OpenFlow switch, you can check current switch configuration from commands such as:
 
 {{{
@@ -89 +95 @@
 }}}
 
-Editing the system configuration requires entering into "enable" mode by typing the 'enable' command and providing the admin password.
-
-From there one can change configuration properties as documented in the Force10 switch documentation.
+Editing the system configuration requires access to the "enable" mode, by typing the 'enable' command and providing the admin password.  From there one can change configuration properties as documented in the Manuals listed above.
 
 == Monitoring ==