Changes between Version 4 and Version 5 of GENILTE/ConnectingUserEquipmentToLTE

Timestamp:

05/22/18 15:51:56 (6 years ago)

Author:

apalfi@bbn.com

Comment:

--

GENILTE/ConnectingUserEquipmentToLTE

@@ -24 +24 @@
 In order to access GENI LTE, you must have a fully configured Base Station at your site that can speak to the central EPC at Rutgers. The steps to do that shall be outlined below.
 
- 1. Acquire a AirSpan Base Station. Here are several in use by GENI LTE sites currently:
+ 1. Acquire a !AirSpan Base Station. Here are several in use by GENI LTE sites currently:
     a. http://www.airspan.com/airsynergy-2000/
     b. https://www.amarisoft.com/products-lte-ue-ots-sdr-pcie/#software (Software only, still need a radio peripheral)
- 2. Modify the default configuration profile in NetSpan in order to correctly set values for the following fields.  This is the minimum set needing to be configured in order to have a working eNB:
+ 2. Modify the default configuration profile in !NetSpan in order to correctly set values for the following fields.  This is the minimum set needing to be configured in order to have a working eNB:
     a. Network Profile - Modify the PLMN and MME IP to site specific values.
     b. Cell Properties - Only important if your site has more than one base station.
     c. Radio Profile - Modify the settings for EARFCN and Bandwidth to match FCC spectrum allocation. 
 
-More detailed specifics of the configuration aspects of Amarisoft Hardware and NetSpan Software may be found at the following wiki: [wiki:GENILTE/LTEDeploymentRutgers GENI LTE Deployment at Rutgers]
+More detailed specifics of the configuration aspects of Amarisoft Hardware and !NetSpan Software may be found at the following wiki: [wiki:GENILTE/LTEDeploymentRutgers GENI LTE Deployment at Rutgers]
 
 == 5. Access Point Names ==