Changes between Version 18 and Version 19 of GENIExperimenter/Tutorials/SystematicExprCaseStudy/SmallTopoQuagga/DesignSetup

Timestamp:

08/05/16 14:35:20 (8 years ago)

Author:

pjayanth@bbn.com

Comment:

--

GENIExperimenter/Tutorials/SystematicExprCaseStudy/SmallTopoQuagga/DesignSetup

@@ -65 +65 @@
  (2) Enter Address for one interface [[BR]]
  (3) Scroll down and enter address for the other interface part of the link. [[BR]]
- (4) Repeat for each of the list shown in the  network configuration address assignment list. [[BR]]
-
-
-=== iii. Delete Routes installed by InstaGENI === #delete
+ (4) Repeat for each of the list shown in the  network configuration address assignment list. 
+
+=== iii. Delete Routes installed by InstaGENI === #del
 To overcome the issues faced in topologies with loops due to the way routes are installed in InstaGENI, we need to delete those routes on each node. This can be done by turning off and then turning on all the interfaces on a node except ''' ''eth0'' '''. The script to do this task can be found at ''' ''http://www.gpolab.bbn.com/experiment-support/Utilities/ClearRoutesIG.tar.gz'' '''. 
 
@@ -203 +202 @@
 
 
-For client and server,  follow the same steps as we followed in the [wiki:GENIExperimenter/Tutorials/SystematicExprCaseStudy/InstallSoftwareQuagga#a4.VerifyInstaGENICustomImage Verify InstaGENI Custom Image] section. We also need to delete any routes installed by InstaGENI. Follow the steps followed in [wiki:GENIExperimenter/Tutorials/SystematicExprCaseStudy/SmallTopoQuagga/DesignSetup#delete Delete Routes installed by InstaGENI] section.
+For client and server,  follow the same steps as we followed in the [wiki:GENIExperimenter/Tutorials/SystematicExprCaseStudy/InstallSoftwareQuagga#a4.VerifyInstaGENICustomImage Verify InstaGENI Custom Image] section. We also need to delete any routes installed by InstaGENI. Follow the steps followed in [wiki:GENIExperimenter/Tutorials/SystematicExprCaseStudy/SmallTopoQuagga/DesignSetup#del Delete Routes installed by InstaGENI] section.
 
 To configure `OSPF` on Client, do the following steps: