Changes between Version 5 and Version 6 of GENIExperimenter/Tutorials/OpenFlowOVS/HW/DesignSetup


Ignore:
Timestamp:
11/20/15 13:13:59 (8 years ago)
Author:
nriga@bbn.com
Comment:

--

Legend:

Unmodified
Added
Removed
Modified
  • GENIExperimenter/Tutorials/OpenFlowOVS/HW/DesignSetup

    v5 v6  
    1919
    2020   * The topology used in this experiment is the same as the one used in the  [wiki:GENIExperimenter/Tutorials/OpenFlowOVS/DesignSetup OpenFlow using OVS] part of this tutorial: Three virtual machines (VMs) connected by an !OpenFlow switch. However this tutorial uses the hardware !OpenFlow switch on the rack instead of a software OVS switch.
    21    * If you have not reserved a controller yet, make sure to create a slice that will run the !OpenFlow controller by reserving a VM running the controller using the request RSpec [http://www.gpolab.bbn.com/exp/OpenFlowOVS/xen-openflow-controller-rspec.xml].  This RSpec is available at the Portal and is called ''XEN OpenFlow Controller''''''''.
     21   * If you have not reserved a controller yet, make sure to create a slice that will run the !OpenFlow controller by reserving a VM running the controller using the request RSpec [http://www.gpolab.bbn.com/exp/OpenFlowOVS/xen-openflow-controller-rspec.xml].  This RSpec is available at the Portal and is called ''XEN !OpenFlow Controller''''''''.
    2222
    2323[[Image(GENIExperimenter/Graphics:SimpleHardwareOpenFlow.jpg,40%)]]