- List all the interfaces of the node
Write down the interface names that correspond to the connections to your hosts. The correspondence is:
- Interface with IP 10.10.1.11 to host1 - ethX
- Interface with IP 10.10.1.12 to host2 - ethY
- Interface with IP 10.10.1.13 to host3 - ethZ
- Be careful not to bring down eth0. This is your control interface, if you bring that interface down you won't be able to login to your host!. For all interfaces other than
eth0 and l0 , remove the IP from the interfaces (your interface names may vary):
- Add all the data interfaces to your switch (bridge):Be careful not to add interface eth0. This is your control interface. You should see three interfaces that start with VLAN, these are your data interfaces. (Use the same interfaces as you used in the previous step.)
-
sudo ovs-vsctl add-port br0 ethX
-
sudo ovs-vsctl add-port br0 ethY
-
sudo ovs-vsctl add-port br0 ethZ
|
|