Changes between Version 81 and Version 82 of GENIExperimenter/Tutorials/OpenFlowOVS/Execute

Timestamp:

07/24/14 12:56:14 (10 years ago)

Author:

sedwards@bbn.com

Comment:

--

GENIExperimenter/Tutorials/OpenFlowOVS/Execute

@@ -155 +155 @@
   You should see at least two table entries: One for ICMP Echo (icmp_code=8) messages from host1 to host2 and one for ICMP Echo Reply (icmp_code=0) messages from host2 to host1.  You may also see flow entries for arp packets.
 
-  6. To see messages go between your switch and your controller (listening on port 6633 of your localhost), run tcpdump on your eth0 interface:
+  6. To see messages go between your switch and your controller (listening on port 6633 of your localhost), run tcpdump on the `eth0` interface of your controller node:
   {{{
   sudo tcpdump -i eth0
   }}}
-  You will see (1) periodic keepalive messages  being exchanged by the switch and the controller, (2) messages from the switch to the controller (e.g. when there is a table miss) and an ICMP Echo message in, and (3) messages from the controller to the switch (e.g. to install new flow entries).
+  You will see (1) periodic keepalive messages being exchanged by the switch and the controller, (2) messages from the switch to the controller (e.g. when there is a table miss) and an ICMP Echo message in, and (3) messages from the controller to the switch (e.g. to install new flow entries).
 
   7. Kill your POX controller by pressing `Ctrl-C`: