Changes between Version 95 and Version 96 of GENIExperimenter/Tutorials/OpenFlowOVS/Execute


Ignore:
Timestamp:
11/04/14 21:55:05 (4 years ago)
Author:
rrhain@bbn.com
Comment:

--

Legend:

Unmodified
Added
Removed
Modified
  • GENIExperimenter/Tutorials/OpenFlowOVS/Execute

    v95 v96  
    269269In the above example we ran a very simple learning switch controller. The power of !OpenFlow comes from the fact that you can decide to forward the packet anyway you want based on the supported !OpenFlow actions. A very simple but powerful modification you can do, is to duplicate all the traffic of the switch out a specific port. This is very useful for application and network analysis. You can imagine that at the port where you duplicate traffic you connect a device that does analysis. For this tutorial we  are going to verify the duplication by doing a `tcpdump`  on a port on the OVS switch.
    270270
    271   1. Use the interfaces that are connected to `host2` and  `host3`. If you haven't note them down you can use the manifest and the MAC address of the interfaces (ovs:if1 and ovs:if2) to figure this out.  Run tcpdump on these interfaces; one in each of the other two terminals you opened. This will allow you to see all traffic going out the interfaces.
     271  1. Use the interfaces that are connected to `host2` and  `host3`. If you haven't note them down you can use the manifest and the MAC address of the interfaces (ovs:if1 and ovs:if2) to figure this out.  Run tcpdump on these interfaces; one in each of the two ovs terminals you opened. This will allow you to see all traffic going out the interfaces.
    272272  {{{
    273273  sudo tcpdump -i <data_interface_name>