Changes between Version 2 and Version 3 of GENIExperimenter/Tutorials/OpenFlowHW/DesignSetup
- Timestamp:
- 12/10/14 14:53:39 (9 years ago)
Legend:
- Unmodified
- Added
- Removed
- Modified
-
GENIExperimenter/Tutorials/OpenFlowHW/DesignSetup
v2 v3 18 18 == Step 1. Obtain resources == 19 19 20 * The topology used in this experiment is the same as the one used in the [wiki:GENIExperimenter/Tutorials/OpenFlowSW/DesignSetup OpenFlow using OVS] part of this tutorial: Three virtual machines (VMs) connected by an OpenFlow switch. However this tutorial uses the hardware !OpenFlow switch on the rack instead of a software OVS switch.20 * The topology used in this experiment is the same as the one used in the [wiki:GENIExperimenter/Tutorials/OpenFlowSW/DesignSetup OpenFlow using OVS] part of this tutorial: Three virtual machines (VMs) connected by an !OpenFlow switch. However this tutorial uses the hardware !OpenFlow switch on the rack instead of a software OVS switch. 21 21 * If you have not reserved a controller yet, make sure you to create a slice that will run the !OpenFlow controller: Reserve a VM running the controller using the request RSpec [http://www.gpolab.bbn.com/exp/OpenFlowOVS/pox-controller.rspec]. This RSpec is available at the Portal and is called '''XEN VM POX Ctrl''''''' 22 22