Changes between Version 1 and Version 2 of GENIExperimenter/Tutorials/OpenFlowHW/DesignSetup


Ignore:
Timestamp:
12/10/14 14:53:14 (9 years ago)
Author:
rrhain@bbn.com
Comment:

--

Legend:

Unmodified
Added
Removed
Modified

  • GENIExperimenter/Tutorials/OpenFlowHW/DesignSetup

    v1 v2  
    1818== Step 1.  Obtain resources ==
    1919
    20    * The topology used in this experiment is the same as the one used in the  [wiki:GENIExperimenter/Tutorials/OpenFlowSW/DesignSetup OpenFlow using OVS] part of this tutorial: Three virtual machines (VMs) connected by an !OpenFLow switch. However this tutorial uses the hardware !OpenFlow switch on the rack instead of a software OVS switch.
     20   * The topology used in this experiment is the same as the one used in the  [wiki:GENIExperimenter/Tutorials/OpenFlowSW/DesignSetup OpenFlow using OVS] part of this tutorial: Three virtual machines (VMs) connected by an OpenFlow switch. However this tutorial uses the hardware !OpenFlow switch on the rack instead of a software OVS switch.
    2121   * If you have not reserved a controller yet, make sure you to create a slice that will run the !OpenFlow controller: Reserve a VM running the controller using the request RSpec [http://www.gpolab.bbn.com/exp/OpenFlowOVS/pox-controller.rspec].  This RSpec is available at the Portal and is called  '''XEN VM POX Ctrl'''''''
    2222