- Click the Generic Node box and drag it onto the canvas.
- To edit the node, double click on the node box.
- From the "Select testbed" drop-down, pick the aggregate assigned to you. DO NOT forget to do this
- Select the node and press the "Duplicate" button. You should now see two node boxes on the canvas.
- Now click near one of the node boxes on the canvas, then click and drag towards the other node. Release when you reach the other node. You should now see a line and a box representing a link connecting the two nodes.
- The canvas should now look like the picture on the right.
|
Figure 3-5 Two nodes connected by a link.
|
- To edit the name of each node, double click on the node box.
- In the "Name" field at the top, replace "node0" with "client".
- Repeat for the node labeled, "node1". In the "Name" field at the top, replace "node1" with "server".
|
Figure 3-6 Edit the name of the VM. Set the Sliver Type on ExoGENI racks.
|
- Now click on the "link" box.
- Enter an IP Address for this node of 10.1.1.1.
- Enter a Mask of 255.255.255.0.
- On the next line down, set that interface to the server's IP address of 10.1.1.2 and a Mask of 255.255.255.0.
|
Figure 3-7 Edit the IP Address and Mask of the VM.
|
- Click the Run button near the top of the window.
|
Figure 3-8 Two VMs connected by a link.
|
- When prompted, pick experiment details, such as your slice, and then hit OK.
|
Figure 3-9 Pick Experiment Details.
|