Changes between Version 2 and Version 3 of GENIExperimenter/Tutorials/ECE375
- Timestamp:
- 08/02/13 15:03:14 (11 years ago)
Legend:
- Unmodified
- Added
- Removed
- Modified
-
GENIExperimenter/Tutorials/ECE375
v2 v3 17 17 The goal of your final experiment is to setup the routing as indicated in Figure 1. You might want to review the slides on IPv4 addressing and routing (also chapter 4.4 in the book) 18 18 19 {{{route picture here}}} 20 19 21 After you have set up the routing correctly, packets from A send to IP address 192.168.2.12 on node C should be routed via node B. Packets from A send to IP address 192.168.3.12 on node C should be directly forwarded to C. You can verify this by performing a traceroute to the respective IP addresses of node C from node A. Since we’re not using a routing algorithm but set the route statically, we will make use of the “route” command. The following link gives you an introduction on how to use the command:
