Changes between Version 1 and Version 2 of GENIExperimenter/Tutorials/ECE375


Ignore:
Timestamp:
08/02/13 15:02:46 (11 years ago)
Author:
epittore@bbn.com
Comment:

--

Legend:

Unmodified
Added
Removed
Modified
  • GENIExperimenter/Tutorials/ECE375

    v1 v2  
    1010'''Set Up'''
    1111
    12 For this experiment you need a GENI account, ssh credentials, and the class VirtualBox image. If you do not already have these, go {{{here}}} for instructions on how to set up your account.
     12For this experiment you need a GENI account, ssh credentials, and the class {{{VirtualBox}}} image. You also need to set up the experiment with Flukes. If you do not already have this set up, go {{{here}}} for instructions on how to set up your account.
    1313
    1414
     15'''Experiment'''
     16
     17The goal of your final experiment is to setup the routing as indicated in Figure 1. You might want to review the slides on IPv4 addressing and routing (also chapter 4.4 in the book)
     18
     19After you have set up the routing correctly, packets from A send to IP address 192.168.2.12 on node C should be routed via node B. Packets from A send to IP address 192.168.3.12 on node C should be directly forwarded to C. You can verify this by performing a traceroute to the respective IP addresses of node C from node A. Since we’re not using a routing algorithm but set the route statically, we will make use of the “route” command. The following link gives you an introduction on how to use the command: