Changes between Version 62 and Version 63 of GENIExperimenter/ExperimentExample-OF-FOAM


Ignore:
Timestamp:
04/18/12 14:37:25 (12 years ago)
Author:
lnevers@bbn.com
Comment:

--

Legend:

Unmodified
Added
Removed
Modified

  • GENIExperimenter/ExperimentExample-OF-FOAM

    v62 v63  
    624624The output for running each of the above commands is attached [http://groups.geni.net/geni/attachment/wiki/GENIExperimenter/ExperimentExample-OF-FOAM/openflow-foam-example.txt here].
    625625
    626 Once you have set up your resources you need to install and run an !OpenFlow Controller to manage your experiment. See the following page for instructions to [http://groups.geni.net/geni/wiki/OpenFlow/GeniBackboneTest#SetupyourOpenFlowcontroller Setup an OpenFlow Controller].  Also, attached is a [http://groups.geni.net/geni/attachment/wiki/GENIExperimenter/ExperimentExample-OF-FOAM/nox-install.txt capture] of the !OpenFlow Controller installation executed for this example.
    627 
    628626
    629627Remember, to renew the slice and slivers reservation time, as the default time is 8 hours. Following are the command to extend the reservation for the resources:
    … …  
    641639The output for running each of the above renew commands is attached [http://groups.geni.net/geni/attachment/wiki/GENIExperimenter/ExperimentExample-OF-FOAM/openflow-foam-renew.txt here].
    642640
     641=== Setup an OpenFlow Controller for the Experiment ===
     642Once you have set up your resources you need to install and run an !OpenFlow Controller to manage your experiment. See the following page for instructions to [http://groups.geni.net/geni/wiki/OpenFlow/GeniBackboneTest#SetupyourOpenFlowcontroller Setup an OpenFlow Controller].  Also, attached is a [http://groups.geni.net/geni/attachment/wiki/GENIExperimenter/ExperimentExample-OF-FOAM/nox-install.txt capture] of the !OpenFlow Controller installation executed for this example.
     643
     644=== FOAM sliver approval ===
     645
     646Each of the !OpenFlow slivers must be approved by an administrator at each of the !OpenFlow Aggregates. You do not need to take any action, an email notification will be sent for each of the FOAM aggregates that looks as follows:
     647
     648[[Imnage(wiki:GENIExperimenter/ExperimentExample-OF-FOAM/FOAM-sliver-approve.jpg)]]
     649
     650In the scenario captured in this page, there are 4 notification one from each of the FOAM aggregates (BBN, Clemson, NLR and Wisconsin.
     651
    643652== Run Experiment ==
    644653