Changes between Version 100 and Version 101 of GENIExperimenter/ExperimentExample-OF-FOAM

Timestamp:

04/20/12 15:13:07 (12 years ago)

Author:

lnevers@bbn.com

Comment:

--

GENIExperimenter/ExperimentExample-OF-FOAM

@@ -159 +159 @@
 To write an OF RSpec you must determine the end-to-end OF path that will be used for the experiment. This section describes this process, which is comprised of the following steps:
 
-Step 1. Collect listresources from all FOAM Aggregate.  Note that these !OpenFlow advertisment RSpec provide insight into all resources at the aggregate, but does not provide any insight into whether they are available. [[BR]]
-Step 2. Review [http://groups.geni.net/geni/wiki/GeniAggregate GeniAggregate] to determine how each experiment MyPLC host maps to the Site's !OpenFlow switch. Determine addresses and ports, and define site specific OF Group rules.  [[BR]]
-Step 3. Using guidelines from the [http://groups.geni.net/geni/wiki/HowTo/WriteOFv3Rspecs#WritingOpenFlowv3requestrspecs Writing OF V3 RSpec] page merge the information from step 1 and 2 to generate the request RSpecs.  [[BR]]
+Step 1. Collect listresources from all FOAM Aggregates.  Note that these !OpenFlow advertisement RSpecs provide insight into all resources at the aggregate, but do not provide any insight into whether they are available. [[BR]]
+Step 2. Review [http://groups.geni.net/geni/wiki/GeniAggregate GeniAggregate] to determine how each experiment MyPLC host maps to the site's !OpenFlow switch. Determine addresses and ports, and define site specific OF Group rules.  [[BR]]
+Step 3. Using guidelines from the [http://groups.geni.net/geni/wiki/HowTo/WriteOFv3Rspecs#WritingOpenFlowv3requestrspecs Writing OF V3 RSpec] page merge the information from Step 2 to generate the request RSpecs.  [[BR]]
 
 Each of the above steps is covered in detail below:
 
 
-=== Step 1: Collect listresources from all FOAM Aggregate ===
+=== Step 1: Collect listresources from all Aggregate ===
 
  1. Clemson FOAM and MyPLC aggregates: