CCN ASSIGNMENT

STEPS FOR SETTING UP

Since this experiment requires to use monitoring tools to monitor the behavior of the network, we use GENI Desktop to enable GEMINI monitoring in our experiment.
If you are not familiar with GEMINI or GENI Desktop, here is a very good tutorial: ​http://groups.geni.net/geni/wiki/GEC16Agenda/InstaGENI

Create an Experimental Topology for Sharing Precipitation data using CCN network

• 1. Download the RSpec from ​http://www.gpolab.bbn.com/experiment-support/CCNExampleExperiment/ccn-precip-pc.rspec (or ​http://www.gpolab.bbn.com/experiment-support/CCNExampleExperiment/ccn-precip-pc-gemini.rspec for and RSpec with GEMINI extensions).
• 2. Follow the tutorial on ​GENIDesktop Tutorial to create the topology using ccn-precip-pc.rspec through ​GENIDesktop on Flack, with GEMINI extension enabled
  

Note: When import the rspec file, Flack interface will ask you which AM to use. Here we use utahemulab.

• 3. Log onto the reserved nodes following instructions here: ​LoginToNodes

Done.

After you created and *renewed* the topology from the Flack interface, you will see a topology like the following with green back ground (which means the resources are up and ready):

Note the GEMINI monitoring node GNutahemulabcm0.

Next: Run Experiment