source: trunk/GENIRacks/ExoGENI/Spiral4/Rspecs/AcceptanceTests/EG-EXP-5/README-EG-EXP-5-scenarios.txt @ 1300

Last change on this file since 1300 was 1299, checked in by, 11 years ago

adding RSpecs for initial run of EG-EXP-5, along with README that describes the scope of each scenario

File size: 1.7 KB
1This file describes the various scenarios that are to be tested as part of the ExoGENI acceptance test EG-EXP-5, the "ExoGENI OpenFlow Network Resources" test case. 
3Each of the scenarios includes 2 BBN Campus VMs which are NOT part of the ExoGENI rack. The OpenFlow flowspaces are managed with the  ExoGENI FOAM aggregate.  For each scenario there are 2 mesoscale remotes, one WAPG node on Internet2 and one MyPLC node on NLR.
5The request RSpecs used in each of the scenarios are captured in a directory matching the scenario name:
7EG-EXP-5-scenario1: This Scenario includes 2 campus VMs with an interface on VLAN 1750, whose flowspaces pass through the ExoGENI OpenFlow switch. Initial run uses 1 experimenter credential to set up all resources.
9EG-EXP-5-scenario1-2exp: This scenario is the same as scenario 1 above, but it is executed by two different GENI accounts.
11EG-EXP-5-scenario2: This scenario includes 2 campus VMs which are not part of the ExoGENI rack. These VMs have and interface on a campus VLAN 3705 2 which is mapped to VLAN 1750 in the ExoGENI rack.
13EG-EXP-5-scenario3: This scenario includes 2 campus VMs with an interface on VLAN 3705. We think that we'd just request some flowspace for this VM, for traffic on VLAN 3705 matching its MAC address or IP address or whatever, on the relevant ports, and voila.
15    A pair of VMs, one with an interface on VLAN 1720 and one on 1721. This is a little more complicated, because our flowspace needs to include:
16        Traffic on VLAN 1720 or VLAN 1721 from the campus uplink port.
17        Traffic on VLAN 1750 from the GENI uplink port that matches your nodes in some way (MAC address, IP address, whatever).
18        A controller that can do VLAN translation.
Note: See TracBrowser for help on using the repository browser.