| 6 | | Select the node/nodes on which you want run your command. Then click on the '''Command''' button. In the small window that shows up as shown in the figure below, click on the '''Set Selection''' button. Make sure you see your selected nodes listed below that button. Then type in the command you would like to run. You can join multiple commands separated by a ''';'''. (Commands are executed in a bash shell) |
| | 6 | If you would like to run a linux command/script on one or more nodes in your slice , you should use this module. To do so |
| | 7 | 1. Select the node/nodes on which you want run your command. |
| | 8 | 2. Then click on the '''Command''' button. In the small window that shows up as shown in the figure below, |
| | 9 | 3. click on the '''Set Selection''' button. Make sure you see your selected nodes listed below that button. |
| | 10 | 4. Then type in the command you would like to run. You can join multiple commands separated by a ''';'''. (Commands are executed in a bash shell) |
| | 11 | |
