Changes between Version 13 and Version 14 of GeniDesktop/Manual/gdfeatures/run

Timestamp:

05/12/16 16:51:04 (8 years ago)

Author:

Hussamuddin Nasir

Comment:

--

GeniDesktop/Manual/gdfeatures/run

@@ -10 +10 @@
 
  
- 1. Click on the '''Command''' button. In the small window that shows up as shown in the figure below.[[br]]2.[[br]](a) Select the node/nodes on which you want run your command.[[br]](b) Click on the '''Set Selection''' button. Make sure you see your selected nodes listed below that button.[[br]]3. Then type in the command you would like to run. You can join multiple commands separated by a ''';'''. (Commands are executed in a bash shell)[[br]]
+1. Click on the '''Command''' button. In the small window that shows up as shown in the figure below.[[br]]2.[[br]](a) Select the node/nodes on which you want run your command.[[br]](b) Click on the '''Set Selection''' button. Make sure you see your selected nodes listed below that button.[[br]]3. Then type in the command you would like to run. You can join multiple commands separated by a ''';'''. (Commands are executed in a bash shell)[[br]]
 
 Once the commands are run, you will see the results of the commands  pop up in a new browser tab/window. (See figure below)