EG-EXP-3: ExoGENI Single Site 100 VM Test
This page captures status for the test case EG-EXP-3, which verifies the ability to support 100 VM in one rack.
Test Status
This section captures the status for each step in the acceptance test plan.
Step | State | Date completed | Ticket | Comments
|
Step 1 | | | |
|
Step 2 | | | |
|
Step 3 | | | |
|
Step 4 | | | |
|
Step 5 | | | |
|
Step 6 | | | |
|
Step 7 | | | |
|
Step 8 | | | |
|
Step 9 | | | |
|
Step 10 | | | |
|
Step 11 | | | |
|
Test Plan Steps
- Request ListResources from BBN ExoGENI.
- Review ListResources output, and identify available resources.
- Write a RSpec that requests 100 VMs evenly distributed across the worker nodes using the default image.
- Create a slice.
- Create a sliver in the slice, using the RSpec defined in step 3.
- Log into several of the VMs, and send traffic to several other systems.
- Step up traffic rates to verify VMs continue to operate with realistic traffic loads.
- Review system statistics and VM isolation (does not include network isolation)
- Review monitoring statistics and check for resource status for CPU, disk, memory utilization, interface counters, uptime, process counts, and active user counts.
- Verify that several VMs running on the same worker node have a distinct MAC address for their interface.
- Verify for several VMs running on the same worker node, that their MAC addresses are learned on the data plane switch.
- Review monitoring statistics and check for resource status for CPU, disk, memory utilization, interface counters, uptime, process counts, and active user counts.
- Stop traffic and delete sliver.