Changes between Version 16 and Version 17 of GENIExperimenter/Tutorials/PortalSimpleLayer2Example/ExecuteExperiment


Ignore:
Timestamp:
03/11/13 19:02:23 (11 years ago)
Author:
sedwards@bbn.com
Comment:

--

Legend:

Unmodified
Added
Removed
Modified
  • GENIExperimenter/Tutorials/PortalSimpleLayer2Example/ExecuteExperiment

    v16 v17  
    7676      * The '''control interface'''. This is the interface from where you access the node, e.g. ssh into your host. The control interface is mainly used for control traffic, i.e. traffic for controlling the node and the experiment. The control interface usually has a publicly routable IP.
    7777      * The '''data interface'''. This is the interface that is used for sending experimental traffic. This is the interface that connects to the other hosts of your experiment through GENI. The links between these interfaces are the ones that allow you to run non-IP experiments.
    78     i. Fill in the worksheet, noting the name and  IP address of the control and of the data interfaces for each node. The data interface is the one that has an IP that starts with 10.
     78    i. Fill in the worksheet, noting the name and  IP address of the control and of the data interfaces for each node. The data interface is the one that has an IP that starts with 10.
     79    '''Note''': The "client" is the node in Utah and the "server" is the node at the GPO (in Massachusetts).  The command prompt on each node says "client" or "server" respectively.
    7980    i. When we reserved the resources, we did not specify the IP address for the data interfaces.  Instead, do this now.  Configure the IP address on the data interface of each node using the desired data IP address from the worksheet :
    8081{{{