Changes between Version 21 and Version 22 of GENIExperimenter/Tutorials/GettingStarted_PartII_Hadoop/Procedure/DesignSetup
- Timestamp:
- 03/07/14 13:40:03 (10 years ago)
Legend:
- Unmodified
- Added
- Removed
- Modified
-
GENIExperimenter/Tutorials/GettingStarted_PartII_Hadoop/Procedure/DesignSetup
v21 v22 241 241 242 242 </ol> 243 <li>Repeat for each of the three nodes.</li> 244 <li>For the link, go to the <i>Interfaces</i> tab and set the IP addresses and masks as specified in the table below.</li> 245 <li>Switch to the properties tab and set the link’s bandwidth 100Mb/s Set capacity: 100000000 (note: Flack will report that this is 100Gb/s but it is actually 100Mb/s) 246 243 </li> 244 <li>Repeat for each of the three nodes. 247 245 <table border="0" cellpadding="0" cellspacing="0"><tr><td><img src="http://groups.geni.net/geni/attachment/wiki/GENIExperimenter/Tutorials/Graphics/warning-icon-hi.png?format=raw" width='50' height='50'/></td><td>Be very careful when entering this information -- these commands will not 248 246 be executed yet, so it will be some time before you will see any relevant 249 247 error messages if there is a mistake here.</td></tr></table> 250 248 </li> 251 249 </ol> 252 250 </td> … … 265 263 </table> 266 264 </td></tr> 265 266 267 <tr><td> 268 <ol type='a' start='5'> 269 270 <li>For the link, go to the <i>Interfaces</i> tab and set the IP addresses and masks as specified in the table below.</li> 271 <li>Switch to the properties tab and set the link’s bandwidth 100Mb/s Set capacity: 100000000 (note: Flack will report that this is 100Gb/s but it is actually 100Mb/s) 272 </li> 273 </ol> 274 <td> 267 275 268 276 </table>