Changes between Version 57 and Version 58 of GENIExperimenter/ExperimentExample-OF-FOAM

Timestamp:

04/18/12 14:20:55 (12 years ago)

Author:

lnevers@bbn.com

Comment:

--

GENIExperimenter/ExperimentExample-OF-FOAM

@@ -624 +624 @@
 The output for running each of the above commands is attached [http://groups.geni.net/geni/attachment/wiki/GENIExperimenter/ExperimentExample-OF-FOAM/openflow-foam-example.txt here].
 
-You should renew the slice and slivers, as the default time is 8 hours. Following are the command to extend the reservation for the resources:
+Once you have set up your resources you need to install and run an !OpenFlow Controller to manage your experiment. See the following page for instructions to [http://groups.geni.net/geni/wiki/OpenFlow/GeniBackboneTest#SetupyourOpenFlowcontroller Setup an OpenFlow Controller].  Also, attached is the log of the [http://groups.geni.net/geni/attachment/wiki/GENIExperimenter/ExperimentExample-OF-FOAM/nox-install.txt OpenFLow Controller Installation] executed for this example.
+
+
+Remember, to renew the slice and slivers reservation time, as the default time is 8 hours. Following are the command to extend the reservation for the resources:
 {{{
  $ ./src/omni.py renewslice  3sites-OF-Exp 2012-04-27
@@ -658 +661 @@
 }}}
 
-Once you have set up your resources you need to install and run an !OpenFlow Controller to manage your experiment. See the following page for instructions on how to set up an [http://groups.geni.net/geni/wiki/OpenFlow/GeniBackboneTest#SetupyourOpenFlowcontroller OpenFlow Controller].  Also attached is the log of an [ xxxx OpenFLow Controller Installation] executed for this example.
+
 
 ----