Changes between Version 116 and Version 117 of GENIExperimenter/ExperimentExample-OF-FOAM

Timestamp:

04/25/12 11:20:41 (12 years ago)

Author:

lnevers@bbn.com

Comment:

--

GENIExperimenter/ExperimentExample-OF-FOAM

@@ -261 +261 @@
 }}}
 
-In addition each of the groups must be allowed to share traffic for the IP subnet range reserved for the experiment, this is done with the following filter defenition:
+In addition each of the groups must be allowed to share traffic for the IP subnet range reserved for the experiment, this is done with the following filter definitions:
 {{{
    <openflow:match>
@@ -283 +283 @@
 
 [[Image(ClemsonOFAggregateResources.jpg)]]
+
+The Clemson !OpenFlow Aggregate image above shows the information required for the !OpenFlow RSpec:
+ * Host ''planetlab4.clemosn.edu'' is connected to port ''39''
+ * The OF switch had a DPID of ''06:d6:00:26:f1:3f:e4:80'' 
+ * The site OF VLAN 1750 is connected to backbone VLAN 3715 on port ''43''
 
 These are the lines from the Advertisement that should be used in the !OpenFlow request RSpec:
@@ -297 +302 @@
 }}}
 
-In addition each of the groups must be allowed to share traffic for the IP subnet range reserved for the experiment:
+In addition each of the groups must be allowed to share traffic for the IP subnet range reserved for the experiment, this is done with the following filter definitions:
 {{{
    <openflow:match>
@@ -320 +325 @@
 [[Image(WisconsinOFAggregateResources.jpg)]]
 
-''Note:'' For the Wisconsin OF switch *only*, you must add 24 to he C port number to determine the !OpenFlow port number.  The host wings-openflow-2.wail.wisc.edu is on port C3 which maps to the !OpenFlow port 51 (48+3).
+
+The Wisonsin !OpenFlow Aggregate image above shows the information required for the !OpenFlow RSpec:
+ * Host ''wings-openflow-2.wail.wisc.edu'' is connected to port ''22''.
+ * The OF switch with the host has a DPID of ''06:d6:00:23:47:cc:44:00'' 
+ * The OF switch with the hosts uses port ''1'' to connect to another switch where VLAN 1750 is mapped to 3715.
+ * The second OF switch uses port ''C3'' to map VLAN 1750 to 3715. Following instruction on diagram, you must add 48 to the C port number to determine the !OpenFlow port number to use in the RSpec. The !OpenFlow port number to use is ''51'' (48+3).
+
 
 These are the lines from the Wisconsin OF Advertisement that should be used in the !OpenFlow request RSpec:
@@ -342 +353 @@
 
 
-In addition each of the groups must be allowed to share traffic for the IP subnet range reserved for the experiment:
+In addition each of the groups must be allowed to share traffic for the IP subnet range reserved for the experiment, this is done with the following filter definitions:
 {{{
     <openflow:match>