Changes between Version 13 and Version 14 of GEC17Agenda/GettingStartedWithGENI_III_GIMI/Procedure/Execute

Timestamp:

07/18/13 16:32:31 (11 years ago)

Author:

divyashri.bhat@gmail.com

Comment:

--

GEC17Agenda/GettingStartedWithGENI_III_GIMI/Procedure/Execute

@@ -182 +182 @@
       * user_irods_target(exper)_iticket
 
-==== 3.3.2 GIMI Init installation ====
+==== 3.2.2 GIMI Init installation ====
 This section describes the installation procedure
 
 
-==== 3.3.3 How to run ====
+==== 3.2.3 How to run ====
 Open a terminal window and run:
 {{{
@@ -272 +272 @@
 
 
-==== 3.4 Experiment descriptor and iRODS ====
+=== 3.3 Experiment descriptor and iRODS ===
 
 '''Initial Experiment Collection''' 
@@ -297 +297 @@
 [[BR]]
 
-== 4. Verification of Topology ==
+=== 3.4 Verification of Topology ===
 After establishing the slice on which the experiment will be executed, the experimenter will be most likely 
 be interested in verifying if the slice has been initiated correctly. In this tutorial, we use an [[http://emmy9.casa.umass.edu/GEC15-GIMI-Tutorial/step1-ping_all.rb OMF experiment script]] that executes pings between neighboring nodes.
@@ -515 +515 @@
 ----
 
-=== 5. Setup Routing in Experiment Topology ===
+=== 3.5 Setup Routing in Experiment Topology ===
 In more complex topologies routing has to be set up. In our case, this is achieved with the aid of an [[http://emmy9.casa.umass.edu/GEC15-GIMI-Tutorial/step2-routing.rb OMF experiment script]]. The one we use for this tutorial is shown below.
 
@@ -613 +613 @@
 ----
 
-=== 3.4 Verification of Routing ===
+=== 3.6 Verification of Routing ===
 After establishing the routing, we use an [[http://emmy9.casa.umass.edu/GEC15-GIMI-Tutorial/step3-ping_e2e.rb OMF experiment script]] that executes pings between each pair of nodes that contains one hop, to verify the correctness of routing setup.